1src Forums - regarding POSE

05-12-2003, 03:46 PM	#1
zohaer21 Senior Member Join Date: Jan 2003 Location: qatar Posts: 152	regarding POSE hi i wanted to know... how do you get the pose to hotsync with the cpu.. i mean there is no usb option in it and i dont have a serial port for hotsyncing... is it possible to hot sync the pose to the cpu then thru networking?

05-12-2003, 04:09 PM	#2
yOyOYoo hello Join Date: May 2002 Location: CA Posts: 1,456	Follow the steps carefully 1. Select the Simulator menu Settings>Communications> Redirect NetLib calls to TCP/IP in order to redirect the NetLib calls to the host machine's TCP/IP stack. 2. Using the Simulator menu Settings>Communications> Communication ports, set the cradle's port to TCP/IP bound to localhost:9. 3. In the HotSync settings for the host computer, enable Network Hotsync. 4. In the HotSync application in the simulation session, set the following settings: - Tap Modem. - Select Options>Modem Sync Prefs and tap Network. Tap OK to save the changes. - Select Options>LANSync Preferences and tap LANSync. Tap OK to save the changes. - Select Options>Primary PC Setup and enter 127.0.0.1 as the Primary PC Address. Tap OK to save the changes. - Select Options>Connection Setup and select Cradle/Cable. Tap Done to save the changes. - Tap Select Service to set your service preferences, and then tap Done. does it work now?

05-13-2003, 04:52 AM	#3
zohaer21 Senior Member Join Date: Jan 2003 Location: qatar Posts: 152	ok here is where the problem lies.. ie the last step "Tap Select Service to set your service preferences, and then tap Done" what do i write here coz the options it gives like at and t etc are not available here.. so when i try to hotsync it fails... its either this last step that gets me screwed or maybe some thing earlier on in the cofiguration i dont do right.. but im sure its the former as i follow the instruction step by step.. thanks

05-13-2003, 08:44 AM	#4
rhart00 Registered User Join Date: Sep 2002 Location: us of a Posts: 1,317	i think you have to put 00 in as the number to dial in the select service screen.