I have the drivers for the Spectec GPS I got through eBay, but I can't get the thing to do any communicating. I'm not sure it is my T|E, or the way I installed the drivers & driver configuration.
I followed the instructions I foundon the Spectec website,
http://www.spectec.com.tw/fix.htm#question2
and the status L.E.D. will flash some when you insert the SD card, but when I run the suggested GPS app (cotoGPS) I dont get any data.
I sent several email messages to the Spectec customer service tech, and one to spectec.com.tw and I have gotten no replies, or even a confirmation email.
Since I see these SDIO GPS units on eBay by the dozens, I'd expect Spectec to back up sales with some customer service. Also, since they have so many different ones (GPS camera, etc) I'd think that they would know what they're doing in reference to PalmOS devices.
There are so many settings for the UART and the SDIO driver, that I may not have something setup right. So I use the settings I'd use as if I was working with PC modem stuff.
I even got the eBay seller to send me a second unit to try, in case the first was defective. The second one works the same as the first.
I even did a hard Reset of my Palm and just installed the SDIO drivers to see if ZLauncher may be in conflict somehow. No difference.
Any ideas?
thx