Help

[nerd]

my ux50 is not responding when i touch the screen with the stylus. only the part where u write your letters and numbers works. what wrong with my clie??? ive already done a hard reset, soft reset and ive tried to calibrate the stylus but its impossible to because nothing happens when i try to touch the middle of the arrow... :confused:

what should i do?
:confused: :confused: :confused:

[Joel]

Welcome to 1src.

Did you just put a screen protector before the problems happened?

[cktlcmd]

Do you have CodeDiver installed and enabled to enlarged the "Preference" application of your UX50? If yes, you have to disable it first, then perform your hard reset to calibrate. Something similar happened to me and I found out that CodeDiver was messing up the digitizer if I enable it to hide the virtual grafitti area of the "Preference" application.

[nerd]

Welcome to 1src.

Did you just put a screen protector before the problems happened?

well i do have a screen protector and it was working but then after a few months with it on, one day it just didnt respond when i touched the screen. i dont know why or how it just stopped working one day and continued till this day. i took the screen protector off and it still didnt work. and i dont think the screen protector had anything to do with it messing up.
is there anything else that would help me fix this problem???
i really want to get it fixed... :(

[nerd]

Do you have CodeDiver installed and enabled to enlarged the "Preference" application of your UX50? If yes, you have to disable it first, then perform your hard reset to calibrate. Something similar happened to me and I found out that CodeDiver was messing up the digitizer if I enable it to hide the virtual grafitti area of the "Preference" application.

whats a CodeDiver??? :confused: i dont think i have something like that. if its something i had to install from downloading it somewhere i dont thing i have it...

[nerd]

can anyone think of what i have to do?????? :confused: :confused: :confused: