Anyone able to use Agendus 9?

[PurpleMD]

I have an NX 73...I can't get the Agendus 9 installer to work correctly. When I install it, the installer runs...then the Clie crashes. I've tried to install after a "warm" reset, without ZLauncher running, I have no hacks and at least two or three megs of RAM free.

Anyone have any ideas? I've already paid for the upgrade, but it's turning into bloatware...I never get to the full functionality of the previous version...they just got the wallpaper feature working in 8.06! WHO KNEW? :confused: I had given up on that one working on my Clie!

PurpleMD

[timt-AZ]

I downloaded the software about 2 weeks ago and it installed without any problems. Maybe you got a bad download. The file I got is called agendusstd_ota_EN.PRC This is actually a nutshell installer program. Once installed it used all of the settings for the v8 and didn't seem to have many improvements. I completely removed agendus. and reinstalled from scratch with the v9 and alot more new settings were available. If I were you I would try downloading the file again and attempt the install. Hope that helps.

PS. I have a NX80 and only had about 2 meg free when I did the install.

Tim

[PurpleMD]

I downloaded the 9.01 version and installed with over 6 MB of free RAM...no joy. I have no idea what the issue is...waste of however much I spent to upgrade.

[karasu]

you must have a conflict. are you using jackflash or some other flash enabler? i would disable all resident apps and try again. worst case, backup your unit and then hard reset. install to clean unit. if that works you have a software conflict.