Hotsync prob, handheld file not found 4003

[technical1]

To All,

Please let me know if you can help me w/this problem.

Whenever I do a hotsync the hotsync log lists the following error:

Protocol Error handheld file not found 4003

Thanks in advance.

[tanker_bob]

To All,

Please let me know if you can help me w/this problem.

Whenever I do a hotsync the hotsync log lists the following error:

Protocol Error handheld file not found 4003

Thanks in advance.
Did you remove something from Flash using JackSprat without disabling its conduit? Did you delete an application from your handheld that used a conduit w/o uninstalling the conduit?

[technical1]

Bob,

Good to hear from you again;

it sounds like this might be it; but I'm green when it comes to disabling/uninstalling conduits.

Please advise w/how to steps.

TIA

[tanker_bob]

The easiest way is to set each conduit to Do Nothing one by one until the message doesn't appear in the log anymore. The last one changed would be the problem.

[technical1]

Bob, thanks for input, that worked. Thought you meant some sort of Windoze uninstall procedure. Anyway I also noticed that beaming is doesn't work. Searched on this site & testing shows that soft reset helps, but how can one tell which file is causing the problem?

When I wipe the T3 & beam to blank unit it just 'snaps to' but file by file method seems too tedious & considering how some apps have support files it'd be hard to tell.

Any ideas?

TIA,

[tanker_bob]

Generally overclocking programs cause beaming problems, and some security programs can as well. There are odd-ball or poorly written programs that can cause problems, but no telling what some of those are.

[technical1]

Bob,

Thanks for the info.