Wireless

[autumn801]

I have a wireless network - Linksys 2.4G Wireless G Broadband Router.

My computer is Windows 2000, and I have the PEG-TH55 unit and i'm trying to connect wireless.

it see's my wireless access point which is the router, but I get
0x1212

I have no WEP enabled so it is a simple setup.
ProfileName: linksys
SISD: linksys
Wep: None

ConnectMode: Infrastructure
AutoConnect - checked.

Advanced setup: IP adress - auto checked
DNS Address: Auto - checked
PowerSaveMode - Enabled checked

Do you have any suggestions.
Thanks

[foghead]

This sounds like the same problem that I reported here. (http://www.cliesource.com/forums/showthread.php?s=&threadid=43855)

Try turning on WEP and see if it works.

[inomad]

thats strange. My wirless g of the same make has worked flawlessly with all of my pdas. Try resetting the router, then updating the firmware.

[Rick_C]

Try disabling the Powersave mode. I have the same wireless router, and I kept getting the same 'Timeout error'. I read another thread with a similar issue, and the general consensus seems to be that the Powersave mode is worthless! BTW, I'm writing this on my TH-55 connected wlrelessly! This PDA is AWESOME! Good Luck!

[depret]

Good Luck!

[krypticide]

Powersave mode works fine on my university wireless network.

[autumn801]

i took the powersave off.
It still does not work.

Do you have any other suggestions?

Thanks

[armyabn1]

i had a similar problem...although I have a wireless B...anyway, my TH55 connected immediately...and QUICKLY...once I assigned it a static IP address in the router settings....my router allows dynamic IPs to be assigned AND specially assigning certain IPs to certain MAC addresses...anyway, thats what I did and it worked immediately

[Mazboy]

I am also having a simlilar issue, my TH55 can scan and see my home network without a problem, but when i try and connect it just times out, any suggestions?

I've tryed with auto IP, static IP, WEP on, WEP off, etc, etc, with no luck!
:(

[Mazboy]

Correction, i have have it working when i have WEP turned off, but cannot connect with WEP on, 64 bit or 128 bit. Anyone got any ideas?

[Peloquin]

try manually entering an IP address rather than letting it get it all auto... set the Secondary Gateway to 4.2.2.2

I had a lot of problems until I manually ented the ip and all gateway info.

[rljyyg]

My Th55 can work on the Linsys Wireless G router by using 64 bits wep.

[Mazboy]

I spent many an hour playing with it but discovered the problem was using a shared key with WEP. I now have it setup using an open key and 128bit WEP and it works great.

[MrNako]

Originally posted by Rick_C
Try disabling the Powersave mode. I have the same wireless router, and I kept getting the same 'Timeout error'. I read another thread with a similar issue, and the general consensus seems to be that the Powersave mode is worthless! BTW, I'm writing this on my TH-55 connected wlrelessly! This PDA is AWESOME! Good Luck!

Did you use graffiti 2?

[sigelang]

ConnectMode: Infrastructure .


Should be "adhoc". (not PDA to PDA)