bertopl
11-11-2003, 07:39 PM
just a little warning on the new version of powerone graph. I was trying this s/w out on the recommendation of a lot of ppl on this board. however, be careful playing around with building "templates"... it has caused three separate hard resets on my ux50... when the ux first locks up, it says that you need to soft reset the machine, but upon soft resetting, a small window immediately pops up that just has a "reset" button on it. you can't push the button on this window, and using the reset hole again only repeats the above cycle... so the only REAL way out is a hard reset!!
I have emailed the vendor's support and they admit to the problem and say a fix is on the way. they confirmed that the bug is in the "templates" module so I'm assuming that other powerone calculators that use "templates" have similar problems... they also said that they are soon to release a "skin" to take advantage of the ux's wide screen!! I'm looking forward to these two updates, but just wanted to warn anyone playing around with this software: do a FULL backup or leave the "templates" alone!!
I really hope they fix this soon. the software looks great otherwise, especially the graphing capabilities. much better than what I'm used to in apcalc...
I have emailed the vendor's support and they admit to the problem and say a fix is on the way. they confirmed that the bug is in the "templates" module so I'm assuming that other powerone calculators that use "templates" have similar problems... they also said that they are soon to release a "skin" to take advantage of the ux's wide screen!! I'm looking forward to these two updates, but just wanted to warn anyone playing around with this software: do a FULL backup or leave the "templates" alone!!
I really hope they fix this soon. the software looks great otherwise, especially the graphing capabilities. much better than what I'm used to in apcalc...