Help needed...upgraded from NR to NX

[gremlin]

Hi guys

I suspect that this topic may have been covered, but I can't seem to find it anywhere.

I have just got a NX (I was a NR user). Now I am not sure how to "transfer" my hotsync settings to the NX. I lots of conduits setup and I would hate to uninstall everything and reinstall for the NX again. Is there an easier way to transfer my hotsync settings to the NX?

Any help is much appreciated!

[Gremlin]

oh yes, another question... can I use the NR cradle on the NX as well?

[*L*F*C*M*]

Gremlin, the best way to go is to do a fresh install on everything. Many programs have different versions for OS5. In addition, for some reason, you cannot hotsync your NX to the NR stuff (or that may be just me) . . .

DO NOT, under any circumstances restore a back up from your NR to your NX. It will make an unholy mess that may require a hard reset to fix . . .

[*L*F*C*M*]

Originally posted by Gremlin
oh yes, another question... can I use the NR cradle on the NX as well? I believe the cradle is cut differently to accomodate the CF card hump)

[n2ifp]

Originally posted by *L*F*C*M*
Gremlin, the best way to go is to do a fresh install on everything. Many programs have different versions for OS5. In addition, for some reason, you cannot hotsync your NX to the NR stuff (or that may be just me) . . .

DO NOT, under any circumstances restore a back up from your NR to your NX. It will make an unholy mess that may require a hard reset to fix . . .

Of course if you want a lot of problems, just ignore L*F*C*M*' s good advice:)!

[n2ifp]

Originally posted by *L*F*C*M*
I believe the cradle is cut differently to accomodate the CF card hump)

Yes, you can use it, it'll fit, but not well.