NX movies won't play on UX50??

[filegrabber]

Whan I try to play my library of movies recorded on an NX70 and NX80 they do not play in the UX50 movie player.

I get the message- "Cannot play the selected movie. This format might be supported."

I have searched through the forums and cannot see an answer- any help greatly appreciated:)

Using an MS Pro...

[lmame]

That is strange because I've done some files for UX and some NX people reported that it was working on their NX...

And the PEGAVR100K does files for every NX / NZ / UX...

How did you managed the files? With Image Converter of the UX, or just a camera capture with the NX?

[filegrabber]

they are mostly camera capture but some are also image converter files- thanks for your help:)

[Eddy]

I think the camera capture on NX70 has 15fps.
& the NX73/80 with 9.6fps if I still remember correctly.
Then the UX supports 30fps on camera capture video clips.

If the above would have any impact at all.
Which I doublt, since the UX should be supporting all the video formats from the previous CLIEs since it has an enhanced playback engine. hum...

[filegrabber]

It shows the thumbnails OK and lists every movie but still the message above everytime???

[filegrabber]

Jusr tried to record a movie with the UX and get- "Error occirred in Multimedia system. Movie Recorder will abort" Happens when stopping recording and makes no difference if recording to MS or internal media:(

[Eddy]

wierd though, Shaun, because I just kept all my previous movies from the NX70 on the same MS which I'm using now on my UX50 & they are working without any problems. :confused:

[lostether]

Originally posted by filegrabber
Jusr tried to record a movie with the UX and get- "Error occirred in Multimedia system. Movie Recorder will abort" Happens when stopping recording and makes no difference if recording to MS or internal media:(

I had an error message much like this on my NZ90 once, and it took a hard reset to cure it. Never found out what caused it, as I restored my system from a backup and all was fine. Wait a minute, I thought you just got an NX80? Are you making the switch or just rying it out?

[filegrabber]

Thanks - looked like a hard reset worked. I was a lot more careful with the files I restored this time and everything is now OK. THANKS AGAIN:)