WL100 Error: no interfaces found

[Investa]

<DIV>I finally got around to setting up WiFi at home and putting my WL100 to work.&nbsp; When I open the Network app and hit connect, the activity light is off.&nbsp; When I attempt to ping my Access Point (D-Link DWL-900AP+) from the Network Log screen I get the message "Error: no interfaces found".&nbsp;&nbsp; Could this somehow be related to the installation of the Pelaca CF driver and a 256MB CF card?&nbsp; I have successfully used the WL100 prior to installing the CF driver.

A quick scan of the CF forum turned up no mention of this.
</DIV>

[n2ifp]

If your not connected, then you can't ping. The WL light must be flashing. Do you get the validation beep when the WL100 is inserted? One user found that they didn't push the WL100 in far enough.

The memory card drivers should have no impact on the WL100!!!

[Investa]

I am getting the validation beep upon insertion. The Link light never iluminates. I plan on reinstalling the drivers, as I have done a hard reset since last i used the card.

Mike

[n2ifp]

Originally posted by Investa
I am getting the validation beep upon insertion. The Link light never iluminates. I plan on reinstalling the drivers, as I have done a hard reset since last i used the card.

Mike

When you got to connect the green light should start flashing, unless&nbsp;you have a bad card or Clie, provided the driver is installed.

Yes,&nbsp;others have had hardware problems, but&nbsp;not many!&nbsp;

[Investa]

Yep, the drivers were not part of the BackupMan restore. Seems to be working now.

Mike

[n2ifp]

Right, you can't rely on the backups for restore, and then sometimes you have to go in check the settings again and it will work. I always installed the driver manually from the MS after a hard reset and restore.

I am glad to hear it's working now!:)

[Investa]

I now plan to keep a copy of the drivers on the MS.

Thanks for the input.

Mike

[n2ifp]

Yes, I kept that, the EruWare driver, MS Pro, system update pack, and JackFlash.