How do do "slash" with Decuma?

[squeff]

I'm starting to warm up to Decuma on my new NX73 -- especially since I have re-learn Graffiti (since G2 has some differences from the Graffiti that was on my 610).  However, I can't figure out how to do "slash" items.  For example, slash-C used to copy.  I want to be able to do this with Decuma, and not the menus, keyboard, or have to switch back to G2.  Any way to do this?

[davidtopham]

You have to draw a slash, starting from the status bar at the bottom (anywhere on it). Note that it will not be shown like it would on the virtual graffiti. Then write the character (e.g. C) into decuma and press the small green arrow at the right of decuma to input the text.

I think this is the only way of doing it, and it is more difficult than doing it with graffiti.

David

[alexasha]

I draw slash from the upper left part of decuma getting over the upper boder. This will bring cut, copy, paste icon and I will select one.

[Unregistered]

If you want a command slash just start the slash on the status bar and slash up and to the right.

For a "/" just draw a slash.