Different views with different hard buttons in Agendus

[wnm]

If I assign Agendus to two hard buttons, is there anyway to have Agendus come up with a specific view? i.e. Week view for date book button, and Todo view for Todo button.

[byte2be]

As of version 5.35 do the following:

Tap Menu>Options>Preferences>buttons

Select the Datebook figure and check Assign to Agendus.
Next select Press Action: Go To View.
Next select Week and then List or Grid1/Grid2, etc.

No hardware button configuration for the To Do view for v 5.35.

I've demoed version 6, but it was too buggy for me and I will wait until it is fairly stable. They have added a lot of stuff regarding the To Do views in this version and I'm not too sure they included this for the hardware buttons. Someone here can probably confirm this.

[wnm]

Thanks. It worked.

[byte2be]

Great. Glad to help.

Just curious. Do you have version 6.00/6.01? If so, does it allow for the To Do view on a hardware button?

[wnm]

6.01, and it does.

[kallykalifornia]

I have 6.01 and the problem that I have is that when I set it up to map a button to a single view, either todo or contact view, and am outside of Agendus and press that button it takes me to the last view I used and then I have to press the button again to get to the assigned view.  I know it is a minor issue, but it annoys me enough to not use the feature.

Kal

[wnm]

I have 6.01, with date book button mapped to agenda view and todo mapped to todo view. They always come up that way with one press.

[kallykalifornia]

Hmmm... I wonder what I am missing/not doing properly.... I set it up the way they recommend it in their manual...  as savy as I am at computers, things like this always seem to be sitting right in front of my face...:rolleyes:

[wnm]

I followed byte2be's directions, and it worked perfectly for me.