game controller mod help

[Unregistered]

I am trying to mod the game controller to work with a n760c. (best buy - $8. Love this site!!!) All the pins on the "t" connector equate to the same ones on the n760 connector. meaning no odd balls pins on the "t" that weren't on the "n". I soldering it up and tested it out, all the buttons just start a hot sync. Either modem or cable depending on the resistor used to short the CNT pin to ground. And yes, I updated drivers! Any ideas here? I would think it would work. All it does is remap the hard buttons and jog dial to the controller. Thanks for the help. Or just reading this.

[s_n_m]

It probably doesn't matter that the pinout is the same, I bet there is some special hardware to let the GC10 work (sony changed *something* IN the NX to make it incompatable with the KB11 (accidentaly), so maybe it is a thing like that that the N series needs to be compatable with the GC10).

[snakeboy]

I was thinking of a lack of RS-232 chip. Or a incompatable one if the N does have one.

[snakeboy]

I don't know why my first post says unregistered?