negishi
05-10-2008, 04:09 PM
I've been using Tomtom Navigator 6 on my Treo 700p without any problems, except the occasional message that there isn't sufficient database or cache memory to run the program. Each time I'd do a battery reset after which the program launched without difficulty.
I recently made a 1 hr trip using the GPS on the 1st leg. When I started to return home I inserted the card and got the "insufficient memory" message. However this time after the battery reset the tomtom logo appeared , followed by about 5 seconds of white screen, and then the Palm logo and a soft reset occurred. I eventually did a hard reset thinking this should clear whatever the problem was, but no luck. Every time I attempt to launch now a reset occurs instead.
Any suggestions would be greatly appreciated. I posted here because I think the problem is primarily Treo-related. For the record, I have 23% of RAM free, 54% currently of cache, and 60% dymanic. A reset doesn't change these numbers
I recently made a 1 hr trip using the GPS on the 1st leg. When I started to return home I inserted the card and got the "insufficient memory" message. However this time after the battery reset the tomtom logo appeared , followed by about 5 seconds of white screen, and then the Palm logo and a soft reset occurred. I eventually did a hard reset thinking this should clear whatever the problem was, but no luck. Every time I attempt to launch now a reset occurs instead.
Any suggestions would be greatly appreciated. I posted here because I think the problem is primarily Treo-related. For the record, I have 23% of RAM free, 54% currently of cache, and 60% dymanic. A reset doesn't change these numbers