BlackBerry batteries?

[Kalamets]

Hello, all. I'm a VERY new member of these forums. I've been reading them almost non-stop for the past day, and registered this morning. I was wondering, though, with all of the internal battery mods and the JC40 mod, is it possible to use the BlackBerry C-S2 batteries for any of these mods with steppers or anything? I'm sitting on quite a few of them. Their specs are 3.7v and 1100mah. Please tell me there is some way to mod them at least into the JC40.

[m0nkeyb0y]

What are the dimensions of the batteries?

[Kalamets]

2.1 x 1.3 x .2 inches.

[Puppetteer]

Dimension: 54.80x34.20x6.05 mm

A tad thick for internal, but WAY too wide. You'd have to use it as an external.

[Kalamets]

That's fine by me. I was thinking of tossing a few into a JC40 mod, but was a little weary about it as they're only 3.7v. I thought I read somewhere that the batteries needed to be like 4.2v or something along those lines.

[m0nkeyb0y]

3.7v is the correct voltage - the UX converts 5v down to 3.7v for charging.

You might be able to fit the Blackberry battery into a JC40 mod, but you'd only get one in there.