PDA

View Full Version : Problems with zquake

nevarDeath
12-06-2006, 01:40 AM
I am trying to get ZQuake running on my LD. Here is my setup:
UDMH giving it 12.1MB
Warpspeed at 552mhz BUS at 221mhz
TechSounds5 - disabled
PAK0.pak full version in LD:\Palm\programs\ZQuake\ID1
PAK1.pak full version in LD:\Palm\programs\ZQuake\ID1

Ok It runs, but when I select new game, it just repeatedly says "Lost Server Connection"
Anybody have any suggestions?
nevarDeath
12-06-2006, 01:49 AM
Huh, actually I just noticed that whenever I run it with UDMH enabled, it gives a low memory warning then crashes...actually runs without it, but still get the lost server connection problem
dmitrygr
12-06-2006, 03:14 AM
warning because you did not setup the udmh settings right.
nevarDeath
12-07-2006, 12:15 AM
I tried ratcheting it down to 8MB as suggested at another forum, but it still did the same thing. Do you have a suggestion for what it should be set at?
dmitrygr
12-07-2006, 01:47 AM
32766 should do well, assuming you have lots of mem free. try after a warm reset. run udmh once. then the game
nevarDeath
12-07-2006, 11:44 AM
huh, I only have 20mb free...Guess I don't really want to play it bad enough to delete almost 13 more MB, but thanks for the help!