Reset Loop. . .help!

[salesrep]

Well, I wanted to try the BatteryTime program and see how my '55 stacks up. While I was at it, I loaded FileZ and the Game Controller (for gc10.) Perhaps I shouldn't have loaded this much in one shot, but I did.

The files I installed:
BatteryTime.prc
BTIME Font.pdb
PToolboxLib.prc
Filez.prc
GameConLoader.prc

It prompted to reset after I hotsync'd, and then when it came back up I got:

"DataMgr.c.Line:9228,Index out of range"

In fact, every time I reset the error comes back up. I did a warm reset and deleted all the files I could find (not sure about BTIMEFont.pdb--not sure if ClieFiles was showing that one to me.) Does anyone have advice on what to delete to get past this?

[dragonsgames]

You could, by chance, reinstall FileZ off a MemoryStick, open FileZ, and delete it. :D

[salesrep]

I did that just now, and made sure those files were gone. Also, I happened to search for that type of error on 1src, and I found one related to NetFront3.1 that was the same Datamgr, but with a different line and error. Their suggestion on those forums was to delete some NF3* files and that would clear up the problem.

So in an attempt to try something, I have deleted the NF3* files that were not ROM, and now I'm still getting a reset, but it is:

'Fatal Exception"

So did I help anything or make it worse?

[DanT]

Ouch. Sorry to hear that.

You need to delete BTIME Font and PToolboxLib too. Anything with BTTM and JHSU creator IDs. CLIE Files shows both files.

Not sure about the GameConLoader. I don't use it.

Good luck!

[kiteandcamera]

I experience occassional reset loops on an NX-80. Often, a warm reset and deletion of recently added files does not always fix the problem. A hard reset may be the only way to break the loop. As long as you have a backup prior to loading the GC-10 drivers and Battery Time, you should be able to easily restore your handheld with a recovery hotsync.